FlexIn CDI - cosmotec

FlexIn

CDI

Industrial air conditioners with inverter technology, for maximum efficiency in critical applications

prodotto_FLEXIN_condizionatore_industriale_per_quadri_elettrici

Cooling capacity With three models, the Flex In range covers a wide range of refrigeration capacities, from 1000W to 4200W
Different installations for every space requirement external, semi flush or flush mounting
Wide range of voltages, with two codes covering the entire voltage range: single-phase 110 ÷ 240 V, 50 ÷ 60Hz, and three-phase 380…480, 50…60 Hz
Protection Degree IP54 / Type12

Cooling capacity
With three models, the Flex In range covers a wide range of refrigeration capacities, from 1000W to 4200W

Different installations for every space requirement
external, semi flush or flush mounting

Wide range of voltages
with two codes covering the entire voltage range: single-phase 110 ÷ 240 V, 50 ÷ 60Hz, and three-phase 380…480, 50…60 Hz

Protection Degree
IP54 / Type12

Inverter technology

Modern industrial enclosures and servers require more accurate temperature control and low energy consumption, even with variable heat loads. In the past, these two requirements were incompatible or only partially met, but now both are available in the new FLEX IN CDI electrical panels air conditioner with inverter technology.

Target: Maximum efficiency

Microchannel condenser: thinner than conventional coils reduces pressure drops and improves airflow over the condenser, reducing power consumption
Electronic expansion valve: optimises evaporation, even in the presence of significant variations in the thermal load, increasing the performance and efficiency of the cooling circuit, with considerable energy and economic benefits
EC fans: the air flow rate follows the cooling capacity to maximise the energy efficiency of the whole system in all operating conditions
BLDC compressor: rotary compressor with BLDC (Brushless Direct Current) motor with advantages in terms of low noise, long life, energy saving

Connectivity 4.0

As a result of an Industry 4.0 approach , the Ethernet port is integrated into the air conditioner’s control board. This allows monitoring of all relevant parameters of the unit (temperatures, operating modes, alarms) via http, Snmp, Modbus TCP/IP protocols).